Page 9 of 54 5100054 BND01O03.docx
Avoid collisions between the system and other devices, walls, ceilings, etc. as these may
cause serious damage to the system.
WARNING – Risk of injury!
The manufacturer must be immediately informed of any damage to the
system. Stop all use of the device until the damage is rectified:
Disconnect the system from the mains. Do not stand or work beneath
the system.
WARNING – Risk of injury!
Do not remove any covers, or open any cable ducts, etc.!
Failure to comply in full with these instructions exempts the manufacturer from all liability
and/or warranty obligations.
Additional installation considerations according IEC 60601-1:2005+AMD1:2012:
When installed in an end-product, consideration must be given to the following:
• Humidity preconditioning treatment shall be considered during end-product
evaluation (clause 5.7)
• The power input measurements must be conducted during the end-product
evaluation with all loads supplied and operated in the least favorable condition.
• Applicable leakage current tests shall be conducted during the end-product
evaluation.
• In the end-product installation, the equipment must have means to isolate its
circuits electrically from the supply mains on all poles simultaneously.
• In the end-product installation, the equipment shall be fused acc. to clause 8.11.5
• The end-product installation has to be conform to the EMV specifications acc. to
clause 17.
5. Transport, Storage and Operational Conditions
5.1. When in Operation
• Temperature: 10 °C to 40 °C
• Relative humidity: 30% to 75%
• Air pressure: 70 kPa to 106 kPa
To Next Page
Loading...
