Maxair CAPR - Page 105

Page 105 P/N 03521015 Rev Q
Battery
• MAXAIR Systems Li-Ion Batteries are designed to be maintenance free. If a battery has any damage or malfunction,
contact Customer Service at 1-800-443-3842, for an RMA (Return Material Authorization) for evaluation and possible
replacement.
• Also refer to the next section, Battery Use and Maintenance, for additional instructions regarding Batteries.
Do not drop
Do not puncture.
Do not immerse in liquid.
Do not attempt to disassemble, open, or
service.
Do not place near or in a ame.
Battery Charger
• MAXAIR Systems Battery Chargers are designed to be maintenance free. If a charger has any damage or
malfunction, contact Customer Service at 1-800-443-3842, for an RMA (Return Material Authorization) for evaluation
and possible replacement.
Do not drop
Do not puncture.
Do not immerse in liquid.
Do not attempt to disassemble, open, or
service.
Do not place near or in a ame.
Disposable Face and Head Covers: DLC Cu󰀨s, Shrouds, Double Shrouds, and Hoods
● The DLC LIne of Face and Head Covers is designed for single use, once on/once o󰀨 the Helmet. Repeated assembly and
disassembly will compromise the attachment mechanism or cause the Helmet mounting to be unstable. The DLC items should
be discarded as contaminated waste after removal from the system and replaced by following the appropriate item assembly
and disassembly procedures in this User’s Instructions and the individual Instructions For Use.
•If there are any tears or breaks or uid penetration in the DLC items, or any issues with the visual clarity of the Lenses, the
DLC item should be replaced by following the appropriate assembly and disassembly procedures.
Filter Cover Cap (FCC)
● The FCC must be inspected before each use. If the FCC is loosened after repeated assembly/disassembly such as to
compromise its attachment mechanism or causes the Helmet mounting to be unstable, or if it has tears or breaks, the FCC
should be replaced by following its assembly and disassembly procedures.
•Particular attention must be made to inspection of the Filter Cartridge (black) Gasket for any damage that could adversely
a󰀨ect its seal with the Helmet. If there is any damage or doubt regarding the seal, replace the Filter Cartridge.