Maxair CAPR - HE DLC Pre-Filter Hood

Page 73 P/N 03521015 Rev Q
WARNING
Use only if package is received unopened and contents
are undamaged. If damage is noted, contact the shipper for
replacement or repair.
Prior to using any MAXAIR
®
System or component, be sure to
be familiar with the system’s NIOSH approved conguration.
Read and understand the User’s Instructions Manual.
Failure to follow the User’s Instructions Manual may be
hazardous to the user’s health.
The institution using this product in any application is
responsible for determining the appropriateness of this
equipment relative to regulatory requirements. Bio-Medical
Devices Intl, Inc. does not recommend the appropriate
systems for a particular institution or facility.
DO NOT use if any component is damaged. If any
components are damaged or contaminated and therefore
unt for safe and e󰀨ective use, they should be replaced
immediately.
Use only MAXAIR Systems/ NIOSH approved compatible
components.
The shrouds are not intended for use against oily particulates
such as paint mist, oil mist or detergents.
NOT for use in atmospheres immediately dangerous to life or
health (IDLH), and atmospheres containing less than 19.5%
oxygen.
Follow current local regulations governing biohazard waste to
safely dispose of used shrouds.
If you need more information, contact your BMDI Sales
Representative, or call BMDI customer service at
1-800-443-3842.
17. HE DLC Pre-Filter Hood
O.N. 2270-01SM
(01031417)
Small-Medium
O.N. 2270-01ML
(01031425)
Medium-Large
1
2
3
4
5
6
1. 2080-03 Helmet and
Power Cord
4. 2000-76 Battery Belt
2. 2165-10 Post Filter
Cartridge
5. 2600-01 Battery Charger
3. 2500-36TSC Battery*
6. 2270-01 DLC Pre-Filter
Hood
Intended Use
The MAXAIR
®
CAPR
®
DLC Pre-Filter Hood Systems are
intended to lter aerosolized and droplet particulates.
Hoods are designed for single use applications.
For Use With
The MAXAIR 2270-01DLC Pre-Filter Hood is a component
of the MAXAIR CAPR Hood Systems and is intended to be
donned with a MAXAIR CAPR Powered Air Purifying Respirator
(PAPR) 2080-03 Helmet and a 2165-10 Filter Cartridge.
Materials
DLC Lens is PETG
DLC Cu󰀨 is Polyurethane
Hood body is plastic coated fabric
Filter is electrostatic lter material
Specications
Temperature Limits: 49
0
C
Eciency Rang: HE
Regulatory
NIOSH
Standard CAPR 2270-01 DLC Pre-Filter Hood
System
*The 2500-30TSC is an alternate battery for the 2500-36TSC.