Page 72 P/N 03521015 Rev Q
9. Connect the Helmet Power Cord to the Battery. Push the
Power Cord Connector into the Battery Receptacle until
the Secure Connection audibly clicks.
10. Loosen headband
Ratchet Knob
(counterclockwise).
11. Hold Helmet in one
hand and pull Cu
down with other hand.
Place chin inside cu
and pull helmet down
onto head.
12. Secure Helmet by tightening Ratchet Knob as tight as
comfortably possible, while ensuring stability. The front
headband should sit within a ½ inch of eyebrows for
good visualization of the Safety LEDs.
13. Pull back of shroud up, over, and down behind helmet.
Slide ngers between face and cu on both sides
from chin to temples to ensure a slight Cu-to-Face
tension.*
14. Pull neck ties around to the front and tie securely.
Leaving about a ½ inch gap between neck and Shroud.
Tuck inner shroud inside body cover.
15. Pull outer shroud down around all sides.
Dong
Reverse steps 9 thru 15 to do Helmet and remove Shroud.
After disconnecting the Battery from the Helmet, connect it to
the Charger.
Donning
WARNING
Refer to Section 9, page 43, Instructions For
Use: Charger, for details on proper use of
chargers and for charging batteries.
To Next Page
Loading...
