Page 82 P/N 03521015 Rev Q
19.Continue pulling Hood inside-out up
and over Hood and HLF to ensure
contaminated outside is folded up
inside.
20. Continue pulling Hood o front
of Helmet releasing the Lens
from its Helmet attachment
points.
17. Untie both Neck and Body Ties.
Either retie Neck ties very loosely or
cut them o Hood to ensure Neck Ties
do not contaminate Helmet, gown, or
wearer.
Do:
21. Discard Hood and HLF
per institutional protocol for
contaminated waste.
18.Grasp both Body Ties and pull up
to bring back bottom of Hood up
and over Helmet.
23. Do and discard gown
per gown supplier
protocol.
26. Disconnect the Helmet Power
Cord from the Battery - push
the Secure Connection Button
down, pull Cord Connector
out, release the Button, and
connect the Battery to the
charger.
25. Lift Helmet up and o Head
24. Loosen Headband by
turning Ratchet Know fully
counterclockwise.
WARNING
Refer to Section 9, page 43,
Instructions For Use: Charger, for
details on proper use of chargers
and for charging batteries.
To Next Page
Loading...
