Proper use
The web guiding system is intended to be used on
machines or systems to guide a web of material.
For indoor operation, see environmental specifications.
Improper use
Operation outside the technical specifications.
Operation in an Ex-area or intrinsically safe area.
Operation as a safety component. The web guiding
system does not hold the web position if power fails.
Outdoor operation.
Any other use than the proper use shall be deemed
inappropriate.
Installation and commissioning
Disconnect power from the FIFE-500 MAX before
connecting or disconnecting any cables.
All cable connectors must be tightened sufficiently to
provide the required connection for the cable shielding.
Any web guiding system which is damaged must not be
installed or put into operation.
Only perform installation, maintenance or repair tasks on
the web guiding system when the machine has been
stopped and is secured from being turned on.
Only perform installation, maintenance or repair tasks on
the web guiding system when there is no electrical power
in the system.
The web guiding system must be securely mounted
before being placed in operation.
Only replacement parts obtained from Maxcess may be
used.
No modifications may be made to the web guiding
system.
Do not place electrical cables under mechanical strain.
WARNING – Death or injury can result from static electric
shocks. Moving webs of material can produce large static
voltage potentials. Protect against electric shocks by
installing a conductive connection between the terminal
marked with the PE symbol on the power connector and the
PE circuit of the building or machine.
To Next Page
Loading...
