11921 Slauson Ave. Santa Fe Springs, CA. 90670 (800) 227-4116 FAX (888) 771-7713
21
CAUTION
To avoid personal injury, use at least 2 people to position Liftgate.
!
4. Use forklift to center Liftgate on rear of
vehicle (FIG. 21-1).
CENTERING LIFTGATE ON TRAILER
FIG. 21-1
5. Bolt the Liftgate installation plates fl ush to trailer slide rails.
Refer to TABLE 21-1 for the correct diagram . Use hex bolts,
bushings, fl at washers and fl ange nuts supplied with installa-
tion kit. Torque mounting bolts to 100 lb-ft.
DIAGRAMS FOR INSTALLATION PLATES
TABLE 21-1
WIDTH BETWEEN
SLIDE RAILS
USE DIAGRAM
48-1/8” FIGS. 22-2 & 22-2A
48-5/8” FIGS. 23-2 & 23-2A
42-1/8” FIGS. 24-2 & 24-2A
42-5/8” FIGS. 25-2 & 25-2A
STEP 1 - INSTALLING LIFTGATE ON TRAILERS- Cont’d
NOTE: Ensure vertical channels on the installation jig are short enough to prevent
interference with underbody of vehicle.
To Next Page
Loading...
