11921 Slauson Ave. Santa Fe Springs, CA. 90670 (800) 227-4116 FAX (888) 771-7713
52
STEP 5 - CONNECT POWER & GROUND CABLES TO
J-BOX - Continued
6. Connect power (+) and ground (-) cables to J-box as shown in FIGS. 49-3 and
50-1.Torque power (+) and ground (-) cable nuts to 20 lb-ft. Tighten each cable
gland nut until the seal has a secure grip on the cable jacket. Ensure the electrical
connections are clean, tight, and protected from corrosion.
4. Form a drip loop on the ground (-)
cable where it enters the cable gland
from outside the J-box mounting
plate (FIG. 52-1).
5. Insert ground (-) cable, from vehicle battery,
through cable gland (FIGS 52-1 and 52-1A).
CONNECTING BATTERY GROUND CABLE (-) AT J-BOX
FIG. 52-1
J-BOX
BATTERY GROUND
CABLE (-)
GROUND CABLE (-)
TERMINAL
FIG. 52-1A
CABLE
GLAND NUT
J-BOX
MOUNTING
PLATE
DRIP LOOP
To Next Page
Loading...
