11921 Slauson Ave. Santa Fe Springs, CA. 90670 (800) 227-4116 FAX (888) 771-7713
61
5/8”
7. Ensure platform is fl ush with vehicle fl oor.
Use adjustment bolts, located at stop roll-
ers, to adjust platform end to approximately
5/8” gap from rear sill (FIGS. 61-1 and
61-1A). Torque each bolt to 100 lb-ft.
REAR SILL
PLATFORM
END
STOP
ROLLER
SLIDER
BOLT
FIG. 61-1A
LOCK
NUT
ADJUSTMENT
NUT
GAP
PLATFORM FINAL IN/OUT ADJUSTMENT
(TOP VIEW)
FIG. 61-1
8. Operate the Liftgate to ensure correct operation without binding
or hitting trailer side sill.
NOTE: Refer to Operating Instructions decal and applicable WARNING &
CAUTION decals.
CAUTION
Operate Liftgate with caution and no load until installation is complete.
STEP 7 - PLATFORM ADJUSTMENT- Continued
To Next Page
Loading...
