McHale V Series Baler
42
6.1.2 Care of the netting system
Before operating the machine, ensure that the following procedure is followed to
ensure improved netter operation:
Clean off rubber and metal feed rollers and check for any tacky material
Once roller cleaning is carried out, ensure to apply talcum powder to the
rubber feed roll
6.1.3 Loading & operating the netter system
NOTE: Cleaning solvents
Never use cleaning agents such as benzene, petrol, turpentine oil or
similar cleaning solvents to clean rubber feed roll, otherwise damage
may occur!
McHale recommend using either of the following:
A cloth soaked in dish washing liquid
Soapy water
This warning is displayed when the roll of net runs out or if
the net fails to feed into the chamber. The red light beside
button 5 will also flash. Press button 5 to restart netting and
the warning will disappear once net starts feeding again.
CAUTION: Heavy net rolls should be handled by two people
Pay attention to the heavy weight of the net roll. It is recommended that
full net rolls should be handled by two people.
NOTE: Net cannot be fed if the knife is already tripped
Net cannot be fed if the knife is already tripped. (Activating the spool
valve in the door close direction automatically resets the net knife.)
CAUTION: Use protective gloves
Use protective gloves for any manual work in this area! Beware of sharp
knife edges.
WARNING: Always think 'Safety First'!
Ensure the PTO is disengaged, the tractor is shut down and ignition key
has been removed.
To Next Page
Loading...
