McHale V Series Baler
43
The following is the procedure for changing a roll or fitting the first roll:
1. Ensure the PTO is disengaged, the
tractor is shut down and ignition key
has been removed.
Slide the new roll of net onto the net
storage space on the platform.
NOTE:
Ensure that the roll is orientated
in the correct direction.
2.
Lift the net roll bar upwards until it locks
in the raised position.
3.
Remove any packaging material and
the empty cardboard core of the
finished net roll and dispose of
responsibly.
Move the new net roll from the storage
position onto the netter cradle
4. Pull approximately 80 cm of net off the
roll. (See CST00869)
Spread the net across the rubber feed
roller.
To Next Page
Loading...
