McHale V Series Baler
54
6.3.4 Additional greasing
There are several additional grease points, like door hooks, which are not served from
the central greasing system and must be greased separately. These points should be
greased based on the schedule listed below.
6. Slowly and gently, rotate the
cartridge holder open and closed, a
quarter turn, several times. Air
between the grease pump and the
cartridge will escape. When a bead of
grease starts to leak out, the
cartridge can be tightened fully.
7. Clean off this bead of grease so dust
and debris does not stick to it. This
dirty grease could get into the grease
pump at the next cartridge change,
causing a blockage of the grease
system.
8. Drop the plunger lock and top up the
chain oil. Then reset the lube count
on the control box.
Grease points DS
Grease points NDS
Grease every 300 bales
Grease every 1,200 bales
To Next Page
Loading...
