mectron Starlight Pro - Installation; Safety Requirements in the Installation Phase

9

4 INSTALLATION
The device must be installed in a suitable place that is convenient for its use.
WARNING:The place where the device is installed must meet the requirements found in
the Chapter 4.1 on page 9 .
4.1 SafetyRequirementsintheInstallationPhase

WARNING: The electrical system of the premises in which the device is installed and used
must comply with the rules in force and the relevant requirements of electrical safety.

WARNING: Riskofexplosion. The device cannot operate in environments where there are


WARNING:Install the device in a safe place protected from impact or accidental water or
liquid spray.

WARNING: Do not install the device above or near sources of heat. Arrange during
installation for a suitable circulation of air around the device.

WARNING:
the charging unit (Figure 5 at page 10 - Ref. B) when the device is on.
CAUTION:The device can be transported but must be handled with care when moved.
CAUTION:
CAUTION: Place the device in such a way as to always have the power plug easily
accessible as it is considered to be a disconnection device.