18
starlight pro
6.4 LightIntensityMeasurement
1. Figure 8 at page 18
intensity sensor without pressing it (Figure 8 at page 18 - Ref. B);
2. Figure 8 at page 18 - Ref. C) to switch on the lamp.
The test LED (Figure 8 at page 18 - Ref. D) will indicate the measured light-intensity:
• Green
• Yellow
A
C
B
D
Figure8 – Light Intensity Measurement
CAUTION:
on the patient and carry out the following checks:
1.
2.
19
).
3.
disconnecting it from the mains) and make sure that it cannot be started by unauthorised
persons. Any repair work on the device should be carried out by an authorised Mectron service
centre.
To Next Page
Loading...
