Handling of
biohazardous
material
Use universal precautions when handling samples and discarding waste.
Handle any exposure according to established laboratory protocol
regulations.
The instructions for analyzer decontamination and disposal can be found on
the Medonic home page, www.medonic.se under support.
If there are any obvious signs of malfunction such as smoke or liquid leaking
out of the instrument proceed as follows:
Disconnect the main power supply immediately by pulling out the
cord from the main supply.
Contact your authorized distributor.
1.5 Warning Signs in Manual
The following warning signs in the manual are used to identify possible
hazards and to call on the operator’s attention to this condition.
Indicates operation procedures that could result
in personal injury if not correctly followed.
Indicates operation procedures that could result
in damage or destruction of equipment if not
strictly observed.
Emphasizes operating procedures that must be
followed to avoid erroneous results.
Indicates that protective clothing, gloves or gog-
gles must be used when performing described
procedures.