17
10. MIT40X testing
The MIT40X has a selectable insulation test range from 10 V to 100 V in 1 V increments. The
test voltage selected is the nominal test voltage. e.g. If 10 V is selected the actual voltage at the
probe tip will be within the stated tolerance of ±1 V.
The MIT40X is supplied with a default setting of 10 V. This can be adjusted in the setup
procedure between 10 V and 100 V. To adjust the insulation test voltage refer to the Setup
procedure.
Testing is performed in exactly the same manner as a standard insulation test in section 9.1
above.
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com
To Next Page
Loading...
