Design and construction subject to change without prior notice!
MEIKO Maschinenbau GmbH & Co. KG, Englerstraße 3, D-77652 Offenburg, Tel.: +49 (0)781/203-0, Fax: +49 (0)781/203-1174
Cleaning the platforms:
Open the inspection doors and inspection flap.
Clean platform.
Close inspection flap.
Press light-up "acknowledge" key.
Use the "up/down" key to move to the next platform
Open inspection flap.
Clean platform.
Close inspection flap.
Press light-up "acknowledge" key.
Use the "up/down" key to move to the next platform
Open inspection flap.
Repeat this process until all vertical conveyor platforms have been cleaned.
Following successful cleaning:
Press the "CLEAN" button.
Now the installation can be turned on or off using the "control on" and "control off" functions.
12.4 Care of stainless steel surfaces
We recommend cleaning the stainless steel surfaces only as required and using cleaning
agents and care products that are suitable for stainless steel.
Lightly soiled parts may be sufficiently cleaned by wiping with a damp cloth or sponge.
Ensure that everything is thoroughly wiped dry after cleaning to avoid limescale residues.
For best results, use only demineralised water.
Do not use aggressive cleaning or scouring agents.
The care products must not attack the stainless steel, form deposits, or cause discoloura-
tion.
Never use cleaning agents that contain hydrochloric acid or chlorine-based bleaches.
Never use cleaning equipment that you have previously used on non-stainless steel in or-
der to avoid external corrosion.
Aggressive external influences due to cleaning and care products that evaporate in the
vicinity of the dishwashing machine, or are caused by direct application, can lead to ma-
chine damage and put the material at risk (e.g. aggressive tile cleaners).
Caution!
Observe the manufacturers' hazard warnings on the original containers and safety data
sheets.
To Next Page
Loading...
