Meiko RF - Top, Covered Tracks; Round Belt Conveying System in Pot Wash Area

Operating instructions for a round-belt conveyor system with vertical conveyor RF with VF
File: BA_RFmitVF_9750655_EN_2017-05.docx Update: 2018-04-10 9750655
35/40
Design and construction subject to change without prior notice!
MEIKO Maschinenbau GmbH & Co. KG, Englerstraße 3, D-77652 Offenburg, Tel.: +49 (0)781/203-0, Fax: +49 (0)781/203-1174
Maintenance work
Daily
Monthly
Every
three
months
Every
six
months
Measured values/note
on completion
15.5 Top, covered tracks
Check temperature and smooth running of all bearings

Check round belt pulleys for function and for damage

Check round belt pulleys for mechanical damage, tension
and surface condition (whether sticky)

Check position of return direction round belts in support
bracket clips

Check corner rollers top and bottom for function and dam-
age

Check drive motors for running noise

Check tray guides before, on and after corners

Check cleanliness of installation

Check light barriers and light switches are working

15.6 Round belt conveying system in pot wash area
Check height limitation switch is working properly

Check tray stacking

Check on/off and EMERGENCY STOP switches are work-
ing properly

Check temperature and smooth running of all bearings

Check round belt pulleys for function and for damage

Check round belt pulleys for mechanical damage, tension
and surface condition (whether sticky)

Check round belt guidance system for damage

Check corner rollers top and bottom for function and dam-
age

Check drive motors for running noise and ventilation

Check tray guides before, on and after corners

Check/replace switch cabinet ventilator/filter

Check the working of the electrical switches and controls
