Operating instructions for a round-belt conveyor system with vertical conveyor RF with VF
File: BA_RFmitVF_9750655_EN_2017-05.docx Update: 2018-04-10 9750655
Design and construction subject to change without prior notice!
MEIKO Maschinenbau GmbH & Co. KG, Englerstraße 3, D-77652 Offenburg, Tel.: +49 (0)781/203-0, Fax: +49 (0)781/203-1174
Measured values/note
on completion
Check tray brake moves easily
Clean tray brake guides and spray with silicone
Check light switches are working and are securely fitted
and mounted
Check temperature and smooth running of all bearings
Check round belt pulleys for function and for damage
Check round belt pulleys for mechanical damage, tension
and surface condition (whether sticky)
Check corner rollers top and bottom for function and dam-
age
Check drive motors for running noise and ventilation
Check tray guides for damage
15.8 Tray infeed device, TST 6/TST 7
Check the gear motor for correct function and noise
Check temperature and smooth running of all bearings
Check round belt pulleys for function and for damage
Check round belt pulleys for mechanical damage, tension
and surface condition (whether sticky)
Check round belt runs evenly
Check reaction time of lifting magnet
Tighten all fixings and connections
Check all switches for correct function, damage and se-
cure fitting
Check TST 7 for combined effect of all functions, check in-
feed process (see "adjustment tray feeding device", TST7
operating instructions)
To Next Page
Loading...
