MELAG Vacuklav 41 B Plus Evolution - Page 48

10 Settings
48
If a device is to be integrated in a pre-existing (practice) network, observe and comply with the following:
ü The IP addresses listed in the table have not yet been assigned in the (practice) network.
ü The device cannot be automatically administered in a dynamic (practice) network (i.e. a DHCP
network).
1. Select theSettings menu →Logging. The
setting wizard opens.
2. Working in the logging wizard, navigate to the window
in which the IP addresses of the individual devices are
listed.
3. Select e.g. the steam sterilizer. The settings window
opens.
4. Select the number block which you wish to change
directly.
5. Use the C button to delete the numbers. Enter a
new number block and confirm with SAVE.
6. Proceed in a similar fashion with the other devices
which are to be integrated in the network.
Log format
Different data is issued depending on the nature of the logging format.
}
The logging format is determined underSettings
→Logging.
You can choose between the following formats.