D33451 | Date 01/2018 15
Construction and description
2.10 Ambient conditions
► The appliance may only be used in enclosed areas and under the following ambient condi-
tions:
Ambient temperature
10 °C to 35 °C
Humidity rh max. 70 %, non-condensing
Overvoltage category II
Pollution degree 2
Altitude of installation max. 2,000 m above sea level
► The appliance may not be used in areas where there is a risk of explosion. The ambient air
must not contain any explosive dusts, gases, vapours or gas-air mixtures. The appliance is
not explosion-proof.
► Heavy dust production or aggressive vapours in the vicinity of the appliance could lead to
sedimentation in the interior and, as a consequence, could result in short circuits or dam-
age to electrical parts. For this reason, sufficient measures to prevent large clouds of dust
or aggressive vapours from developing should be taken.
2.11 Scope of delivery
► Power cable
► 1 or 2 stainless steel perforated sheets (load capacity: 15 kg each)
► 1 stainless steel water tray (only for appliances with passive humidity control)
► 1 water tank (only for appliances with active humidity control)
► Gas connection hose (depending on the model: one to three)
► Silicone plugs (2 units)
► USB storage medium with software and AtmoCONTROL manual
► the operating instructions at hand
► Calibration certificates
► Separately packaged fastening material for wall mounting (see page 19)
2.12 Optional accessories
► USB to Ethernet converter (Fig. 7). Makes it
possible to connect the Ethernet connection
interface (see page 12) to the USB port of
a computer / laptop.
Fig. 7 USB to Ethernet converter
To Next Page
Loading...
