D33451 | Date 01/2018 25
Operation and control
5.4 Loading the appliance
WARNING
When loading the appliance with an unsuitable load, poisonous or
explosive vapours or gases may be produced. This could cause the
appliance to explode, and people could be severely injured or poi-
soned. The appliance may only be loaded with materials which do
not form any toxic or explosive vapours when heated up and cannot
ignite (see also Intended use on page 8). If there is any doubt as
to the composition of materials, they must not be loaded into the
appliance.
NOTICE
► Check the chamber load for chemical compatibility with the materials of the appliance (see
page 11).
Insert the sliding steel grids or sliding shelves. The maximum number or grids / shelves and the
load capacity are specified in the technical data overview from page 13 .
Load the chamber leaving
enough space between the
items so that proper air
circulation in the interior is
guaranteed. Do not place any
of the chamber load on the
bottom, touching the side
walls or right below the
ceiling of the chamber (Fig.
15, see also the "correct
loading" sticker on the
appliance).
In case of improper loading
(not enough space between
the items), the set tempera-
ture may be exceeded or it
may take longer until it is
reached.
5.5 Operating the appliance
5.5.1 ControlCOCKPIT
In manual operation, the desired parameters are entered at the ControlCOCKPIT on the front
of the appliance (Fig. 16 and Fig. 17 ). You can also make basic settings here (menu mode). Ad-
ditionally, warning messages are displayed, e.g. if the temperature is exceeded. In programme
mode, the parameters defined, the programme description, the programme segment cur-
rently active and programme duration remaining are displayed (for a more detailed descrip-
tion, see page 30).
Fig. 15 Correct placement of the chamber load
To Next Page
Loading...
