Un setting After an Alarm
If an alarm has occurred whilst the alarm system is full or part set, the display will indicate
the detection circuit that was triggered when you unset the system. Once the cause of the
alarm has been established the system must be reset, see “ Resetting after an alar m” on
page 11.
Enter Your Code
Time Left > 0022
ALARM 03
17:31.02 01/01
? ? ? ?
1
2
? ? ? ? ? ? ? ?
0022
CA.03
1
2
1
2
LOUNGE DETECTOR
17:31.02 01/01
LCD Remote St arburst Remote
LED Rem ote
1. Enter the premises via the prescribed entry route and proceed directly to the remote
keypad. The internal sounders generate an interrupted tone. The display will show the
remaining entry time.
2. Enter your 4 digit passcode before the entry timer expires. The internal sounders will
stop and the display will show the circuit that caused the alarm.
3. Refer to “ Resetting Aft er an Alarm” on page 11.
If circu it text ha s been programmed then the display on the LCD and
Starburst remote keyp ads will alternate between the circuit number and
the circuit text at step (2).
NOTES
10
To Next Page
Loading...
