Operating Your Alar m System
Introducti on
Passcodes
Access to the system is gained by entering a 4 digit passcode. Every time you wish to use
the system your passcode must be entered correctly.
U ser Types
The TS690 and TS690ID can have up to 15 separate users each user is assigned a
passcode, and a user level. The user level defines what the user can access within the user
menus, for a definition of each user level see “Set-up New Users ” pag e 28.
U ser Men us
The system has 2 users menus, with each menu having between 9 and 10 options. User
menu 1 is accessed by entering your passcode followed by the [ENT] key. Access to user
menus and options will depend on your user level. When a menu option is selected you
may abandon the option by pressing the [ESC] key. To leave the user menus and return the
system to its original state simply keep pressing the [ESC] key until the display shows “OPEN”.
Banner Messag e
The banner message is normally shown on the top line of display when the system is unset
or full set. This message is configured by your alarm company and is usually set to the alarm
company's name.
Engineer on site
When your alarm company has an engineer on site and is logged into the system, the
keypads will show “ENGINEER ON SITE”. You can continue to operate the system as normal,
if required. The message is automatically cleared when a user passcode is entered.
6
To Next Page
Loading...
