A.C. OFF
AUX TAMP
BATT FLT
24H R OM'T
ALARM 05
AUX 06
Fault Finding
Display Messages
Displays Description
There is no mains power to the control panel and the alarm system is now
running on its standby battery. The system will also generate a chime tone
every minute to warn you that the fault exists, to silence the chime tones
simply enter your passcode. If the mains power is not restored you may not
be able to set the alarm system. If the fault persists the standby battery will
eventually run flat. Contact your alarm company for further advice.
A full alarm has occurred from a detection circuit (circuit 05). This message
is normally display after unsetting the alarm system. Before the system can
be set again the alarm system must be reset, see “Resetting After an Alarm”
on page 11.
An auxiliary alarm has occurred from a detection circuit (circuit 06). The type
of alarm is silent and will activate the appropriate outputs. To reset the alarm
simply enter your passcode followed by [ESC].
The control panel auxiliary or bell tamper circuits have been activated. If the
fault is not cleared you will not be able to set the alarm system. To silence the
alarm simply enter your passcode. Contact your alarm company for further
advice.
The alarm system standby battery has developed a fault, normally because
the system mains power is not present. If the fault is not cleared you will not
be able to set the alarm system. To silence the alarm simply enter your
passcode. Contact your alarm company for further advice.
One or more circuits have been isolated from the system. For full details
refer to “Isolate / Re-Instate Shunt Group” on page 19.
AC OFF
17:30 01 Jan
A.C. OFF
PF
ALARM 05
17:30 01 Jan
ALARM 05
CA.05
AUXILIARY 06
17:30 01 Jan
AUX 06
AU.06
AUX/BEL TAMPER
17:30 01 Jan
AUX TAMP
AT
BATTERY FAULT
17:30 01 Jan
BATT FLT
BF
CCTS ISOLATED
17:30 01 Jan
24HR OM'T
CI
40
To Next Page
Loading...
