Omit Circui ts (Cont.)
1. From the unset (open) mode enter your passcode and press [ENT] to select user
menu 1.
2. Whilst user menu 1 is selected. Press [7] to select the omit circuits option.
3. Select the circuit you require to omit by either entering the circuit number or by using
the [A] and [C] keys to scroll up and down through the circuits.
4. When the required circuit number is displayed press the [B] key to alternate between
“Armed” and “Omitted”. If a low tone is heard when pressing the [B] key the selected
circuit cannot be omitted.
5. When the display shows the required setting for the selected circuit, press the [ENT]
key to accept. A rising multi-tone will be heard and the display will show the next
available circuit.
6. If required repeat from step (3) for other circuits, When you have selected all the
required circuits, press the [ESC] key.
a) If you have selected 24hr circuits, the system will automatically return to the
unset mode and the display will indicate that circuits are isolated.
b) If you have only selected night circuits, the system will return to user menu 1.
From user menu 1 you must press [0] to full set, [A], [B] or [C] for part set.
If you have s elected night circuit to be omitt ed, you must perform a full or
par tsetwhilstusermenui sselected.Ifyoureturntosystemope n a llselected
circui ts will be cancelled.
NOTES
22
To Next Page
Loading...
