Metrohm 774 - Page 113

5.10 The remote control tree
774 Oven Sample Processor, Instructions for use
107
:
├ .Finalseq Final sequence - 5.11.1.8
│ ├ .1 Line number of the command -
│ │ ├ .Cmd Command nop, MOVE, LIFT, 5.11.1.9
│ │ └.∗ SAMPLE, HEATER, DEF
│ │ FLOW, DOS, SCAN,
│ ∗ CTRL, WAIT, RACK
│ :
│ └ .100 Sequence end NOP
│
├ .Report Report definitions - 5.11.1.10
│ ├ .Assign Type of report none, short, full, param,
│ │ config, Usermeth
│ └ .TDelta measuring interval of temp. (s) 1…10…60
│
├ .Changer Changer settings - 5.11.1.10
│ ├ .RackNo Rack number 0...16
│ ├ .L1Rate Lift speed tower 1 3...12 mm/s
│ ├ .L2Rate Lift speed tower 2 3...12 mm/s
│ ├ .ShRate Turning speed of the rack 3...20 w/s
│ ├ .ShDir Turning direction of the rack +,–,auto.
│ └ .ModeSample Reaction to error MOVE, display
│
├ .TimeoutSet Timeout settings - 5.11.1.12
│ ├ .HTime HEATER timeout off, 0…999 -
│ ├ .HAction Reaction to timeout cont., STOP -
│ ├ .STime SCAN timeout off, 0…999 -
│ └ .SAction Reaction to timeout cont., ERROR -
│
├ .Gas Gas flow settings - 5.11.1.12
│ ├ .UnitFlow Unit of gas flow display mL/min, L/h -
│ ├ .MinFlow Minimal gas flow 0…999 -
│ ├ .MaxFlow Maximum gas flow 0…900…999 -
│ ├ .Select Type of carrier gas Air, others, N2 -
│ └ .Otherfac Factor for 'other' gases 0.001…1…9.999 -
│
├ .DosimatSet Settings for dosing unit - 5.11.1.14
│ ├ .DosUnitNo Dosing unit number 1...12
│ ├
.1 Dosing unit 1 -
│ │ ├ .DosRate Dosing speed 0.01...160 ml/min, max.
│ │ ├ .FillRate Filling speed 0.01...160 ml/min, max.
│ │ ├ .DosTube Dosing outlet 1...4
│ │ ├ .FillTube Filling inlet 1...2...4
│ │ ├ .ExchTube Rinse inlet 1...2...4
│ │ ├ .PrepTube Preparation outlet 1...4
│ │ └ .EmptyTube Air inlet on emptying 1...4
│ :
│ └
.12
│ :
│ └ . EmptyTube Air inlet on emptying 1...4
│
└
.ManStop Reaction to manual stop -
├ .RemCtl Command via remote STOP device1, 5.11.1.15
│ 14 x 1, 0 or ∗ (bin)
├ .RSCtl Command via RS232 &M;$S, 14 ASCII characters
├ .FLOW Gas flow control cont., off
└ .HEATER Heater control INIT, off, 50…250