Metrohm 774 - Usermeth; Assembly

5.10 The remote control tree
774 Oven Sample Processor, Instructions for use
113
: :
│ ├ .Heater Heater messages -
│ │ ├ .T Changes of target temperature on, off
│ │ └ .S When heater is switched off on, off
│ │
│ └ .E When an error occurs on, off
│
├ .PowerOn RESET (power on) $G 5.11.4.10
├ .Initialize Set default values $G 5.11.4.11
│ └ .Select Selection of branch param, config,
│ assembly, setup, all
├ .RamInit Initialization of working mem. $G 5.11.4.12
└ .InstrNo Instrument number - 5.11.4.13
└ .Value Description 8 ASCII characters
(not available in manual operation)
5.10.6 &UserMeth
Object Description Input range Reference
& Root
:
├ UserMeth User defined methods
: ├ .FreeMemory Memory available read only 5.11.5.1
├ .Recall Load method $G 5.11.5.2
│ └ .Name Method name 8 ASCII characters
├ .Store Save method $G
│ └ .Name Method name 8 ASCII characters
├ .Delete Delete method $G
│ └ .Name Method name 8 ASCII characters
├ .DelAll Delete all methods $G
└ .List List of methods - 5.11.5.3
∗
├ .1 Method 1
∗ ├ .Name Method name read only
└ .Bytes Method size in bytes read only
5.10.7 &Assembly
Object Description Input range Reference
& Root
:
├ Assembly Assembly control
: ├ .Sample Beaker position $G 5.11.6.1
│ ├ .Func Selection of function =, +, –
│ └ .Value Value of function 0...1...999
│
├ .Move Turning the rack $G, $S 5.11.6.2
│ ├ .Target Lift selection 1, 2
│ └ .Position Beaker or position sample, spec.1...8, 1...999
: