Metrohm 774 - Setup

5 Detailed description
774 Oven Sample Processor, Instructions for use
112
5.10.5 &Setup
Object Description Input range Reference
& Root
:
├ Setup Settings for the operating mode -
: ├ .IdReport Report identification on, off 5.11.4.1
├ .Keycode Send key code on, off 5.11.4.2
├ .Tree Sending format of path info 5.11.4.3
│ ├ .Short Short format of path on, off
│ └ .ChangedOnly Paths of modified nodes only on, off
│
├ .Trace Message on changed values on, off 5.11.4.4
│
├ .Lock Lock key functions - 5.11.4.5
│ ├ .Keyboard Lock all keyboard keys on, off
│ ├ .Config Lock <CONFIG> key on, off
│ ├ .Parameter Lock <PARAM> key on, off
│ ├ .UserMeth Lock all method functions on, off
│ │ ├ .Recall Lock "loading" on, off
│ │ ├ .Store Lock "saving" on, off
│ │ └ .Delete Lock "deletion" on, off
│ └ .Display Lock display function on, off
│
├ .Mode Setting the waiting time
│
└ .StartWait Waiting time after start on, off 5.11.4.6
│
├ .SendMeas Automatic message for meas. values
│ ├ .Sendstatus Switch on/off on, off 5.11.4.9
│ ├ .Interval Sending interval 1…4…999
│ │
│ └ .Meas Measuring point - 5.11.4.8
│ ├ .CyclNo Send cycle number on, off
│ ├ .OvenTemp Send temperatur on, off
│ └ .GasFlow Send gas flow rate on, off
│
├ .AutoInfo Automatic message for changes
│ ├ .Status Switch AutoInfo on/off on, off 5.11.4.9
│ ├ .P When mains is switched on on, off
│ │
│ ├ .Ch Changer messages -
│ │ ├ .G When method started on, off
│ │ ├ .GC When start is initiated on, off
│ │ ├ .R When changer is "ready" on, off
│ │ ├ .S When changer is stopped on, off
│ │ ├ .H When changer is on "hold" on, off
│ │ ├ .C Continue after "hold" on, off
│ │ ├ .B Begin of method on, off
│ │ ├ .F End of process on, off
│ │ ├ .OM Begin start sequence "OMove" on, off
│ │ └ .CM End final sequence "CMove" on, off
: :