Metrohm 774 - Usermeth

5.11 Description of the remote control commands
774 Oven Sample Processor, Instructions for use
127
.Heater.S Stop: Switching off of the heater
.E Error: Message with error number (see page 104)
Format of AutoInfo messages:
(space)!device name"AutoInfo node"
Example: !Oven1".G"
5.11.4.10 Setup.PowerOn $G
Simulation of "power on". The method last used is ready for operation.
5.11.4.11 Setup.Initialize $G
Setup.Initialize.Select param, config, setup,
assembly, all
Setting of default values for the following branches:
param: Method parameters (sets empty method '
∗∗∗∗∗∗∗∗')
config: Configuration, branch &Config
setup: Branch &Setup
assembly: Branch &Assembly
all: All values of the entire tree.
Initialization is triggered with &Setup.Initialize $G.
5.11.4.12 Setup.RamInit $G
Initialization of the entire working memory. All parameters will be set to de-
fault; error messages will be deleted.
5.11.4.13 Setup.InstrNo.Value 8 ASCII characters
Device number. Essential for service purposes. The device number must
not be altered.
5.11.5 &UserMeth …
5.11.5.1 UserMeth.FreeMemory read only
$Q queries the size of free memory (in bytes), available for user methods.
5.11.5.2 UserMeth.Recall $G
UserMeth.Recall.Name 8 ASCII characters
UserMeth.Store $G
UserMeth.Store.Name 8 ASCII characters
UserMeth.Delete $G
UserMeth.Delete.Name 8 ASCII characters
UserMeth.DelAll $G
Management of the internal method memory: loading, storing and deletion
of methods. The execution of a function is performed by sending $G to the
corresponding node, after entering the method name. Do not use preced-
ing or succeeding blanks in method names!
.DelAll;$G deletes all method in the user memory.
5.11.5.3 UserMeth.List.1.Name read only
UserMeth.List.Bytes read only
for each method
List of all method in the user method memory including method name and
file size in bytes.