5.2 The keyboard
774 Oven Sample Processor, Instructions for use
49
Key
Normal state Editing
QUIT
Abort current command
• Whilst a method is running,
you can abort a command
currently running with the
<QUIT> key and continue
with the next command. This is
practical if a programmed
waiting time is to be shortened
or, in the case of a SCAN
command, the expected signal
cannot be recorded.
Quit error messages
• <QUIT> acknowledges error
messages. During method
processing the sample
changer goes into the 'HOLD'
state after this. After this, you
can continue with the next
command line with
<START> or stop the se-
quence with <STOP>
• The command at which the
error message occurred is al-
ways continued (in Manual
mode).
Abort Entry
• The <QUIT> key interrupts
the entry of a parameter. The
original entry is reset.
• The next highest menu level or
the normal state is selected.
• Any changed data of a menu
or command line is not
adopted in this case. This is
signalled by a beep. See
<ENTER> key.
• <QUIT> acknowledges error
messages.
ENTE R
Accept data, next line
• The <ENTER> key accepts
the value entered and selects
the next menu line.
• A modification of data or pa-
rameters must always
be
confirmed by <ENTER>, oth-
erwise the change will not be
accepted.
• If a change in a parameter is
not confirmed by <ENTER>
and another menu line is ac-
cessed, the previous value will
be reinstated. This is indicated
by an acoustic signal.
To Next Page
Loading...
