1647LHZ EM-9517-B Rev.10
MG CO., LTD. www.mgco.jp
5-2-55 Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN
(4) Make sure that the watertight packing is placed behind the front cover regardless of necessity of water-tightness.
(5) Insert the unit into the panel cutout.
(6) Push the mounting brackets into the grooves on both sides of the rear module, until they hit the panel’s rear side.
IMPORTANT
To conform to degree of protection IP66, conrm visually that the packing is not contorted, cut off or excessively run off
the edge after installation.
Watertight packing
Bracket
Fixing groove
To Next Page
Loading...
