MG 47 Series - Operating Procedure

5847LHZ EM-9517-B Rev.10
MG CO., LTD. www.mgco.jp
5-2-55 Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN
7.1 OPERATING PROCEDURE
NOTE
• Procedures to change ‘DISP’ to ‘SCLE’ are described
here.
• To change ‘SCLE’ to ‘DISP’, the procedures are same.
Select ‘DISP’ in Step 3.
1
Hold down Scale/↑ button for 3 seconds or more to move on to
Scaling Setting Mode.
• The input type is indicated.
• ‘Zro’ and ‘Spn’ indicators turn on.
2
Press Alarm/↓ or Scale/↑ button to go to the analog output
function mode setting.
• ‘DISP’ is indicated.
• ‘Fnc’ indicator turns on.
3
Press Shift or Up button to select ‘SCLE’.
4
Press Alarm/↓ or Scale/↑ button to apply the new setting.
• And the next parameter setting is indicated.
NOTE
• Press Alarm/↓ button, and the analog output 0% adjustment ‘ADJ’ will be indicated.
• Press Scale/↑ button, and the decimal point position will be indicated.
5
Hold down Alarm/↓ or Scale/↑ button for 1 second or more to return to Measuring Mode.
2,4,
5
1,2,
4,5
3
3
Blinking