MG 47 Series - Main Display Blinking at Alarm; Operating Procedure

7547LHZ EM-9517-B Rev.10
MG CO., LTD. www.mgco.jp
5-2-55 Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN
8.7 MAIN DISPLAY BLINKING AT ALARM
Main display blinking interval at alarm can be specied. The interval can be selected among those shown in the following
table.
■ BLINKING INTERVAL AT ALARM
DISPLAY FUNCTION DEFAULT VALUE
No blinking
Blinking in 1.0 second intervals
Blinking in 0.5 second intervals
Blinking in 0.2 second intervals
Blinking in 0.1 second intervals
8.7.1 OPERATING PROCEDURE
NOTE
The following gures are display examples. The displays
depend on the settings.
1
Hold down Alarm/↓ button for 3 seconds or more to move on
to Alarm Setting Mode.
• The alarm point is indicated.
• ‘HH’, ‘H’, ‘L’, ‘LL’ and ‘Fnc’ indicators turn on.
NOTE
• ‘ALM2’ or ‘ALM4’ is indicated depending on the setting.
• When “Dual alarm” is selected for the alarm point parameter, ‘HH’ and ‘LL’ indicators do not turn on.
2
Press Alarm/↓ or Scale/↑ button to go to the setting of the main
display blinking at alarm.
• The main display blinking at alarm is indicated.
• ‘Fnc’ indicator turns on.
NOTE
‘B 0’, ‘B 1’, ‘B 2’, ‘B 3’ or ‘B 4’ is indicated depending on the setting.
1,2,
4,5
2,4,
5
3
3