MG 47 Series - Wiring Power

2047LHZ EM-9517-B Rev.10
MG CO., LTD. www.mgco.jp
5-2-55 Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN
NOTE
Example of contact protection circuit with inductive load
Power
47LHZ
Inductive load
Varistor RC
circuit
Diode
C
R
■ DC powered
Power
47LHZ
Inductive load
Varistor RC
circuit
C
R
■ AC powered
U U
* It is effective to connect a varistor across a load with the supply voltage 24 to 28 V, and across a contact with 100 to 200 V.
1.6.7 WIRING POWER
Connect power according to the power input code. The power specications are shown in the
following table.
CODE RATING PERMISSIBLE RANGE
M2 100 to 240 V AC 85 to 264 V AC, 50/60 Hz approx. 6.5 VA
R 24 V DC ±10% approx. 3 W
P 110 V DC 85 to 150 V DC approx. 3 W
IMPORTANT
• For safety, make sure that wiring is performed by qualied personnel only.
• In order to prevent potential electric shock, wire the unit after turning off the power supply and making sure that the
power is not supplied to the cable.
• Use wires as thick as possible and twist them from the end.
• For DC power, conrm the polarity.
Power
+
‒
AC power
DC power
10
9
U(+) V(–)