MG 47 Series - Component Identification

1047LHZ EM-9517-B Rev.10
MG CO., LTD. www.mgco.jp
5-2-55 Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN
1.4 COMPONENT IDENTIFICATION
■ FRONT VIEW
BUTTON FUNCTION
Max/Min Used to switch the main display to show the present value, MAX value or MIN
value, and to reset the MAX and MIN values. Also used to cancel a set item.
Alarm/
↓
Used to conrm the alarm setpoints, to move on to the alarm and other setting
modes, or to shift through setting items in each setting mode.
Scale/
↑
Used to move on to the scaling and other setting modes, or to shift through
setting items in each setting mode.
Shift Used to move on to the setting standby status of each setting mode and to
shift through display digits in each setting item.
Up Used to change setting values in a setting standby mode.
NOTE
• The engineering unit sticker label position is our recommended position.
• When an engineering unit is specied by the Ordering Information Sheet, the unit(s) will be shipped with the sticker
label put on the above position.
Display
Engineering unit
sticker label position