2147LHZ EM-9517-B Rev.10
MG CO., LTD. www.mgco.jp
5-2-55 Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN
1.6.8 INSTALLING/SEPARATING TERMINAL BLOCK
The terminal block is separable in two pieces. Tighten (loosen) uniformly two screws on both sides of the terminal block to
install (separate).
Torque: 0.6 N∙m
IMPORTANT
Be sure to turn off the power supply, input signal and power supply to the output relays before installing/separating the
terminal block.
1.6.9 ATTACHING/REMOVING TERMINAL COVER
Be sure to put the terminal cover on for safety after wiring.
■ ATTACHING TERMINAL COVER
Fit the convex part A of the meter in the concave part B of the terminal cover and push the cover until it clicks into place.
Terminal block
Terminal block screw
Terminal cover
B
A
To Next Page
Loading...
