MG 47 Series - Alarm Setpoint; Alarm Setpoint List; Operating Procedure

6447LHZ EM-9517-B Rev.10
MG CO., LTD. www.mgco.jp
5-2-55 Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN
8.2 ALARM SETPOINT
Alarm setpoints can be set within the range of -19999 to 19999. However the alarm is not provided in setting the setpoint
beyond the set display scaling range. Set the setpoints within the valid range. All alarm setpoints are disabled (reset to
‘----’ status) when the input type has been changed.
8.2.1 ALARM SETPOINT LIST
PARAMETER DEFAULT VALUE
LL alarm setpoint
L alarm setpoint
H alarm setpoint
HH alarm setpoint
8.2.2 OPERATING PROCEDURE
NOTE
• The following gures are display examples. The dis-
plays depend on the settings.
• With “Dual alarm” selected for the alarm point param-
eter, the LL and HH alarm setpoints are disabled.
1
Hold down Alarm/↓ button for 3 seconds or more to move on
to Alarm Setting Mode.
• The alarm point is indicated.
• ‘HH’, ‘H’, ‘L’, ‘LL’ and ‘Fnc’ indicators turn on.
NOTE
• ‘ALM2’ or ‘ALM4’ is indicated depending on the setting.
• When “Dual alarm” is selected for the alarm point parameter, ‘HH’ and ‘LL’ indicators do not turn on.
1,2,
5
2,5
3,4
4
Blinking