MG 47 Series - Going Back Automatically to Measuring Mode

7947LHZ EM-9517-B Rev.10
MG CO., LTD. www.mgco.jp
5-2-55 Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN
10. GOING BACK AUTOMATICALLY TO MEASURING MODE
The display goes back automatically to Measuring Mode if the front buttons are left untouched for the specied time period
while it is in one of the setting modes. This time period is called automatic return time and can be set within the range of
1 to 99 seconds (Table 1). With the value set to ‘R 00’, the display must always be exited manually from the setting mode.
The display does not go back automatically to Measuring Mode depending on the modes (Table 2).
■ TABLE 1: AUTOMATIC RETURN TIME
DISPLAY FUNCTION DEFAULT VALUE
Automatic return disabled
to
1 to 99 seconds
■ TABLE 2: AUTOMATIC RETURN IN EACH MODE
MODE OPERATION SETTING TIME OUT
Measuring Mode Conrming alarm setpoint Enabled
Displaying MAX or MIN value Disabled
Scaling Setting Mode Enabled
Alarm Setting Mode Enabled
Advanced Setting Mode Enabled
Lockout Setting Mode Enabled
Loop Test Output Mode Disabled