3847LHZ EM-9517-B Rev.10
MG CO., LTD. www.mgco.jp
5-2-55 Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN
4.2.2 OPERATING PROCEDURE
NOTE
The left gure shows a display example (default value
of input type ‘HF’). The display depends on the settings.
Refer to 4.2.1 DISPLAY SCALING LIST for details.
1
Conrm the wiring, and turn on the power.
• All the indications turn on for approximately 3 seconds and then
the display moves on to Measuring Mode.
NOTE
Indication ‘S.ERR’ may blink, which shows the input out of the measur-
ing range and does not show the unit failure.
2
Hold down Scale/↑ button for 3 seconds or more to move on to
Scaling Setting Mode.
• The input type is indicated.
• ‘Zro’ and ‘Spn’ indicators turn on.
NOTE
Some alarm indicators turn on with the function indicators. The alarm indication is due to the last status before mode
transition held but does not show the unit failure.
3
Press Alarm/↓ or Scale/↑ button to go to the display scaling
value A setting.
• The display scaling value A is indicated.
• ‘Zro’ and ‘D/P’ indicators turn on.
NOTE
Skip to Step 7 if the default value is acceptable.
3,6
2,3,
6
4,5
5
■ Immediately after power on (all indicators on)
■ Measuring Mode
*1 Display depends on the settings and input.
To Next Page
Loading...
