MG 47 Series - Operating Procedure

8347LHZ EM-9517-B Rev.10
MG CO., LTD. www.mgco.jp
5-2-55 Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN
11.1 OPERATING PROCEDURE
NOTE
The following gures are display examples. The displays
depend on the settings.
1
Hold down Alarm/↓ and Scale/↑ buttons at once for 3 seconds
or more to move on to Advanced Setting Mode.
• The brightness is indicated.
• ‘D/P’ and ‘Fnc’ indicators turn on.
NOTE
‘C 1’, ‘C 2’, ‘C 3’, ‘C 4’ or ‘C 5’ is indicated depending on the setting.
2
Press Alarm/↓ or Scale/↑ button to go to the display refreshing
rate setting.
• The display refreshing rate is indicated.
• ‘Fnc’ indicator turns on.
NOTE
The display refreshing rate is indicated within the range of ‘F00.0’ to ‘F99.9’ depending on the setting.
3
Press Shift button to shift the display into the setting standby
mode.
• The third digit starts blinking, to which you can apply changes.
4
Press Shift and Up buttons to set the display refreshing rate.
• Set within the range of ‘F00.0’ to ‘F99.9’.
1,2,
5,6
1,2,
5,6
3,4
4
Blinking