MG 47 Series - Transition Time to Lockout Setting Mode; Operating Procedure

9347LHZ EM-9517-B Rev.10
MG CO., LTD. www.mgco.jp
5-2-55 Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN
13.4 TRANSITION TIME TO LOCKOUT SETTING MODE
Time duration to hold down the buttons for transition to Lockout Setting Mode can be set within the range of 0 to 99 sec-
onds. The default value is 5 seconds.
13.4.1 OPERATING PROCEDURE
NOTE
The following gures are display examples. The displays
depend on the settings.
1
Hold down Alarm/↓ and Scale/↑ buttons at once for 3 seconds
or more to move on to Advanced Setting Mode.
• The brightness is indicated.
• ‘D/P’ and ‘Fnc’ indicators turn on.
NOTE
‘C 1’, ‘C 2’, ‘C 3’, ‘C 4’ or ‘C 5’ is indicated depending on the setting.
2
Press Alarm/↓ or Scale/↑ button to go to the setting of the tran-
sition time to Lockout Setting Mode.
• The transition time to Lockout Setting Mode is indicated.
• ‘D/P’ and ‘Fnc’ indicators turn on.
NOTE
The transition time is indicated within the range of ‘P 00’ to ‘P 99’ depending on the setting.
3
Press Shift button to shift the display into the setting standby
mode.
• The second digit starts blinking, to which you can apply changes.
1,2,
5,6
1,2,
5,6
3,4
4
Blinking