MG 47 Series - Installation

1547LHZ EM-9517-B Rev.10
MG CO., LTD. www.mgco.jp
5-2-55 Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN
1.5.3 INSTALLATION
(1) Remove the terminal cover.
(a) Insert the minus tip of a screwdriver into a hole at the lower left corner of the cover.
(b) Pull the handle upward.
(c) Then insert the screwdriver into a hole at the lower right corner.
(d) Pull the handle upward to separate the terminal cover.
(2) Remove the mounting brackets.
(a) Flip a tab of a bracket.
(b) Then pull the bracket toward the terminal block to remove it.
(3) Put the terminal cover through the panel cutout.
Terminal cover
(a)
(b)
(c)
(d)
Bracket
Tab
(a)
(b)
Terminal cover
Panel