947LHZ EM-9517-B Rev.10
MG CO., LTD. www.mgco.jp
5-2-55 Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN
■ HANDLING CAUTIONS
• The unit is designed to function as soon as power is supplied, however, a warm up for 10 minutes is required for satisfy-
ing complete performance described in the data sheet.
• Use the unit within the noted supply power voltage and rated load.
• The last measured values are held in mode transition. Take this into consideration when conguring the control system.
• Clean the surface of the unit with wet soft cloth. Do not use organic solvent such like benzine, thinner and alcohol. Doing
so may result in deformation or discoloration of the unit.
• When abnormality is found such like smokes, unusual smell and abnormal noises coming from the unit, immediately cut
the power supply and stop using it.
■ TO ENSURE DUSTPROOF AND WATERPROOF (degree of protection IP66)
To ensure dustproof and waterproof for front panel follow conditions below.
• Observe the designated panel cutout size (W92 × H45 mm) specied by us.
• The watertight packing included in the product package must be placed between the body and panel when installing on
the panel.
• Insert the unit into the panel cutout, and fasten both mounting brackets tightly until they hit the panel.
• After installation, conrm that there are no following abnormalities.
– The packing is contorted.
– There are some spaces between front panel and panel.
– The packing is run off the edge.
– The packing is cut off.
– There are foreign objects sticking.
To Next Page
Loading...
