MG 47 Series - Page 26

2647LHZ EM-9517-B Rev.10
MG CO., LTD. www.mgco.jp
5-2-55 Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN
■ SETTING VALUE SELECTION
1
Press Shift button to shift the display into the setting standby
mode.
• The current set value starts blinking.
2
Press Up button to select your desired setting value.
3
Press Alarm/↓ or Scale/↑ button to apply the new setting.
• The next or previous parameter setting is indicated.
■ DECIMAL POINT POSITION SELECTION
1
Press Shift button to shift the display into the setting standby
mode.
• The current set value starts blinking.
2
Press Up button to select a desired decimal point position.
3
Press Alarm/↓ or Scale/↑ button to apply the new setting.
• The next or previous parameter setting is indicated.
*
1 Display depands on the specications and settings.
*
1 Display depands on the specications and settings.