MG 47 Series - Page 30

3047LHZ EM-9517-B Rev.10
MG CO., LTD. www.mgco.jp
5-2-55 Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN
3
Press Shift button to shift the display into the setting standby
mode.
• The indication ‘H55’ starts blinking, to which you can apply
changes.
4
Press Up button to select the input type.
• Select ‘HF’ (measuring range 10 – 500 Hz).
NOTE
Refer to 3.1 INPUT TYPE LIST for selectable input types.
5
Press Alarm/↓ or Scale/↑ button to apply the new setting.
• And the next parameter setting is indicated.
NOTE
• Press Alarm/↓ button, and the input scaling value A will be indicated.
• Press Scale/↑ button, and the decimal point position will be indicated, or the analog output 100% adjustment ‘ADJ’ will
be indicated with DC output.
6
■ TO GO ON TO SET THE INPUT SCALING VALUE A,
Skip to Step 3 in “4.1 STEP 1. INPUT SCALING VALUE A”.
■ TO QUIT,
Hold down Alarm/↓ or Scale/↑ button for 1 second or more to return to Measuring Mode.
NOTE
■ IF THE FRONT BUTTONS ARE LEFT UNTOUCHED…
• The indication turns on with applying the last changes after the specied time period (default: 15 sec.) while it is in the
setting standby mode (indication blinking in Step 3 and 4).
• The display goes back automatically to Measuring Mode after the specied time period (default: 15 sec.) in one of the
other modes.
• This time period (automatic return time) is congurable. (Refer to 10. GOING BACK AUTOMATICALLY TO MEASUR-
ING MODE.)
■ TO ABORT A SETTING…
• Hold down Max/Min button for 1 second or more in the setting standby mode (indication blinking in Step 3 and 4) to
return to Measuring Mode without applying the last changes.
• If you get lost in a setting mode, you can execute initialization. (Refer to 16.2 INITIALIZING SETTING VALUES.)
Blinking
Blinking