MG 47 Series - Page 32

3247LHZ EM-9517-B Rev.10
MG CO., LTD. www.mgco.jp
5-2-55 Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN
■ RELATION BETWEEN INPUT SCALING AND DISPLAY SCALING
The relation between input scaling and display scaling is as shown in the following gure.
e.g. To display 25 – 65 Hz input as 25.00 – 65.00 Hz
■ PROCEDURE TO SET SCALING VALUES
• Flow in setting scaling values
5-step settings are necessary to set scaling values.
• Operating procedure to set scaling values
Following pages describe operating procedures in each step to set the input scaling to 25 – 65 Hz, and the display scaling
to 25.00 – 65.00 Hz as an example.
5.0 Hz
Input scaling value A
25.0 Hz
Display scaling value A
25.00 Hz
‘HF’
Input type
Input scaling
Display scaling
600.0 Hz
Input scaling value B
65.0 Hz
Display scaling value B
65.00 Hz
STEP 5STEP 4STEP 3STEP 2STEP 1
Setting input
scaling value A
Setting
display
scaling
value A
Setting
input
scaling
value B
Setting
display
scaling
value B
Setting
decimal
point
position