3547LHZ EM-9517-B Rev.10
MG CO., LTD. www.mgco.jp
5-2-55 Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN
4
Press Shift button to shift the display into the setting standby
mode.
• The forth digit starts blinking, to which you can apply changes.
• ‘Tch’ indicator turns off.
5
Press Shift and Up buttons to set to ‘025.0’.
• Press Shift button to go to the next digit and Up button to change
the blinking value.
NOTE
• ‘025.0’ is a display example. Set any value within the setting range.
• ‘Min’ and ‘Max’ indicators start blinking when the set value is within invalid range or is same as the input scaling value B.
Return the setting within the valid range.
6
Press Alarm/↓ or Scale/↑ button to apply the new setting.
• And the next parameter setting is indicated.
NOTE
• Press Alarm/↓ button, and the display scaling value A will be indicated within the range of -19999 to 19999 depending
on the setting.
• Press Scale/↑ button, and the input type will be indicated.
7
■ TO GO ON TO SET THE DISPLAY SCALING VALUE A,
Skip to Step 3 in “4.2 STEP 2. DISPLAY SCALING VALUE A”.
■ TO QUIT,
Hold down Alarm/↓ or Scale/↑ button for 1 second or more to return to Measuring Mode.
Blinking
Blinking
To Next Page
Loading...
