MG 47 Series - Page 7

747LHZ EM-9517-B Rev.10
MG CO., LTD. www.mgco.jp
5-2-55 Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN
Tighten the terminal blocks and terminal block screws with a specied torque.
• Excessive fastening may result in damage of the screws and loose screws may occasionally result in ignition.
Do not throw the unit into the re.
• Doing so may result in rupture of the electronic component.
Never discompose or remodel the unit.
• Doing so may result in electric shock, malfunction or injury.
Do not connect or remove the unit while its power is on.
• Doing so may result in electric shock, malfunction or injury.
Do not allow ne shavings or wire scraps to enter the unit in machining screws or wiring.
• Doing so may result in malfunction of the unit.
Make sure to attach the terminal cover.
• Failure to do so may result in electric shock.
Do not pull the wires connecting to the unit.
• Doing so may result in electric shock, damage of the unit or injury.
Do not use the unit in an atmosphere where combustible gas is present.
• Doing so may result in inammation, ignition, or smoke.
Do not cover the ventilation slits with cables, etc.
• Doing so may result in malfunction or heating.