7247LHZ EM-9517-B Rev.10
MG CO., LTD. www.mgco.jp
5-2-55 Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN
3
Press Shift button to shift the display into the setting standby
mode.
• The second digit starts blinking, to which you can apply changes.
4
Press Shift and Up buttons to set the LL (L, H or HH) ON delay time.
• Set within the range of 00 to 99.
5
Press Alarm/↓ or Scale/↑ button to apply the new setting.
• And the next parameter setting is indicated.
NOTE
• Press Alarm/↓ button, and the LL (L, H or HH) coil at alarm ‘RYEN’ or ‘RYDN’ will be indicated depending on the setting.
• Press Scale/↑ button, and the LL (L, H or HH) deadband will be indicated within the range of 0000 to 9999 depending
on the setting.
6
■ TO GO ON TO SET ANOTHER ON DELAY TIMES,
Repeat operation from Step 2.
■ TO SET THE NEXT PARAMETER,
Skip to Step 2 in “8.6 ALARM OUTPUT LOGIC (coil energized or de-energized at alarm)”.
■ TO QUIT,
Hold down Alarm/↓ or Scale/↑ button for 1 second or more to return to Measuring Mode.
Blinking
To Next Page
Loading...
